Gamdias APOLLO M1 Mid Tower Gaming Case
Espousing an asymmetry mesh as a frontal panel, APOLLO M1 provides not only a unique look but also maximum air inflow through the case. With two extremely large 200 mm ARGB suckers, APOLLO M1's suckers are effective at erecting up air inflow and cooling down interal factors. Enormous suckers contemporaneously satisfy the pursuit of cooling effectiveness and the satisfaction of having two 200 mm ARGB suckers. To satisfy PC builders'and gamers'crave for further RGB, each I/ O harborage is girdled by neo chrome streaming light with further than 20 lighting goods. APOLLO M1 supports connection to compatible motherboards (5v 3- leg) to achieve system-wide RGB lighting synchronization, makes it easier to unite your case from RGB chaos to pleasing visual goods. Building upon inner beauty of the case, a vented power force cloak at the bottom of the case surrounds the PSU with cutouts displaying the side of the PSU. A magnetically held dust sludge, located on top of the APOLLO M1 to minimize dust entering the case. With attractions holding the sludge to the case, makes it easy to remove and clean the washable dust sludge. To make a minimalistic style, the side tempered glass is fitted from the reverse of case, leaving thumb screws to hold the tempered glass in place. A cleanser design displaying the internal factors of the PC. A single easy drive button, controls the 2 ARGB suckers and lights girdled the I/ O harborage, cycling though the different goods and LED out. Another button controls the suckers; high, medial, and low speed, whichever suites your cooling needs. APOLLO M1 is amid-tower case with asymmetry mesh frontal panel and two extremely large RGB lighting binary ring suckers on the front. With this design, the pursuit of high heat dispersion, increase air inflow, and eye catching design is achieved. The Concurrence of this covering is CPU cooler height limitation 170 mm, VGA length limitation 330 mm and PSU length limitation 170 mm.
